2009 Kis Serrento How To Remove Door Panel

Remove the triangle panel located behind the mirror there are 3 push clips on the back side.

2009 kis serrento how to remove door panel.

Move the tool towards the hinge area and repeat while holding the loose portion away from the door. There is a clear door liner glued to the door. Remove all visable screws from panel and arm rest. Once the panel is off the door use the small flat head screwdriver to disconnect the power window switch.

I kind of tugged on the top corner to release that clip then the front then the back. Make sure that the rear hatch is securely latched. Slide it back or forth til you hit a stop. The third is in the back corner attached to the top of the door panel.

That should be a plastic pop in twist metal tool to pull panel away from the door. 3 the panel will expose the 3 main bolts that need to be removed. Inner edge screw cover. Down the rear hatch firmly.

Then move to the inner edge of the door panel and pry out the round plastic screw cover. One is at the top and one is at the front corner both attached to the metal door frame. Use a flat thin tool or piece of metal and slip it between the panel and the metal door frame. Start at the bottom of the trim panel and insert the door panel removal tool.

Leave the switch in the door panel. 4 the cable harness needs to be removed this is located behind the door panel. Be careful of the paint. It certainly does not make any sense for the repair department to remove the door panel diagnose the problem as a defective door latch replace the door panel charge the customer 110 for the diagnosis and then if the customer brings the car in again for repair charge an additional 400 so they can remove the door panel again and replace.

Pry against the metal portion of the door until you feel the fasteners pop. 2 use a small screwdriver to pry it away from the door. Even though the doors may be unlocked the rear door will not open by pulling the inner door handle until rear door child. Work your way around the panel until you ve released all the clips then lift out and up to remove the panel.

Set the two screw covers aside in a safe place. Closing the rear hatch to open the rear door pull the outside to close the rear hatch lower and push door handle. Demontáž kliky zadních dveří. Pry out at small notch.

Remove the one screw behind the screw cover. Close the rear door. Pry out the round screw cover with a small flathead screwdriver. Slip it in about 2 inches.